Waeco PerfectView LCD250 Instrucciones De Montaje página 43

PerfectView LCD250
Insulate the plug connection with the insulating tape supplied. Overlap every layer of
the insulating tape by one half of its width.
Attach the cables securely in the vehicles to prevent tripping hazards. This can be per-
formed by using cable binders, insulating tape or gluing in place with adhesives.
Note
I
Only start sealing through-holes when you have completed all installation work
on the camera and have laid the required cable lengths.
7.5 Connecting the rear view system to the power supply (fig. k,
page 10)
The circuit diagram for the rear view video system is located in fig. k, page 10.
No. Description
1 Monitor
2 7-pin mini DIN plug
3 Connection cable
4 7-pin mini DIN socket
5 12 V positive cable (red): Connection to the positive pole of the voltage source
6 Earth cable (black): Connection to the negative pole of the voltage source
7 5-pin DIN socket (connection to camera 1)
8 5-pin DIN socket (connection to camera 2)
9 Cable (green): Control input for the connection to the reversing lights
10 Cable (white): Control input for the connection to the indicators (side camera)
11 5-pin DIN plug
12 System cable
13 6-pin mini DIN socket
14 6-pin mini DIN plug
15 Camera
Observe the following instructions when laying the connection cable:
Note
I
Feed the connection cable through existing ducts or other openings where pos-
sible e. g. ventilation grilles. If no appropriate ducts or openings are available
you will need to drill a hole of ∅ 20 mm. Check beforehand that there is sufficient
space on the other side for the drill head to come out (fig. 2, page 4).
Mounting the camera and monitor
43