Waeco PerfectView LCD250 Instrucciones De Montaje página 46

Using the LCD-monitor
8.5 Setting the monitor (fig. 0, page 6)
To set the monitor to suit your requirements, proceed as follows:
Press the "MENU" button (4) once to set the desired brightness.
The LED "C1" (7) starts flashing.
Press the "–" button (5) to reduce the brightness.
Press the "+" button (6) to increase the brightness.
Press the "MODE" button (3) to exit setup mode.
Press the "MENU" button (4) twice to set the desired contrast.
The LED "C2" (8) starts flashing.
Press the "–" button (5) to reduce the contrast.
Press the "+" button (6) to increase the contrast.
Press the button "MODE" button (3) to exit setup mode.
Press the "MENU" button (4) three times to set the desired tint.
The "COLOR" LED (9) starts flashing.
Press the "–" button (5) to reduce the tint.
Press the "+" button (6) to increase the tint.
Press the button "MODE" button (3) to exit setup mode.
Note
I
You can reset the monitor to the factory settings for brightness, contrast, tint and
volume.
To do this, proceed as follows:
Press the "MENU" button (4) once.
The LED "C1" (7) starts flashing.
Press the "C1/C2" button (2).
8.6 Selecting the camera (fig. 0, page 6)
If you switch from camera 1 to camera 2 or vice versa, press the "C1/C2" button (2).
The monitor switches from camera 1 to camera 2 or vice-versa.
Note
I
If you have connected the green cable to the reversing light and it is electrically
charged, camera 2 will be activated automatically.
46
PerfectView LCD250