Seat Inclination; Backrest Adjusting; Transport In The Car; Use Of The Wheelchair As Seat In A Motor Vehicle - Vermeiren Inovys II Manual De Instrucciones

Seat inclination:

Backrest adjusting:

1. Pull lever c on the right side (see label) towards the grab handle d to adjust the angle
of the backrest.
2. Pull/Push the backrest in the desired position (0° to + 54° ), the gas pressure spring shall
be pressed in/out.
3. Loosen the lever c, to block the gas pressure spring.
If your wheelchair features drum brakes, the levers c c c c are used as brakes; additional
levers e e e e have been mounted for adjusting angle of backrest and seat inclination.
These levers e e e e can be triggered with the thumb.

2.18 Transport in the car

WARNING:
Risk of injury – See that the wheelchair is attached properly. So you
   
can avoid injury from the passengers during collision or sudden braking.
WARNING:
Risk of injury – Use for attaching the wheelchair and passenger
   
NEVER the same seatbelt.
To transport the wheelchair in the car use following steps:
1. Set the seat in a horizontal position and the backrest vertically.
2. Remove footrests, arm supports and accessories (ex. headrest, ...).
3. Store footrests, arm supports and accessories safely.
4. If possible, fold the wheelchair and remove the wheels.
5. Place the wheelchair in the luggage place with 2 persons.
6. If the wheelchair and the passenger compartment is NOT separated, attach the
frame of the wheelchair securely to the vehicle. You can use the available safety
belts in the vehicle.
7. Place the patient in the recommended existing seats with their seatbelt systems.

2.19 Use of the wheelchair as seat in a motor vehicle

WARNING:
The wheelchair has passed the crash of ISO 7176-19: 2008 and, as
   
such, has been designed and tested for use only as forward-facing seat in a
motor vehicle.
WARNING:
    The wheelchair's pelvic belt alone is not suited as an occupant
restraint belt.
1. Pull lever c on the left side (see label)
towards the grab handle d to adjust the seat
inclination.
Label
2. Pull/Push the seat in the desired position (0° t o
+ 21° ), the gas pressure spring shall be pressed
in/out.
3. Loosen the lever c, to block the gas pressure
spring.
Label
ƒ‰‡
Inovys II
2011-11