Aeroarc 320; Front Panel Layout - Solter AEROTIG 3320 DC Manual De Instrucciones

MEMORIES
The equipment automatically memories the most recent values used the in each work mode. This enables the user to The equipment automatically memories the most recent values used the in each work mode. This enables the user to The equipment automatically memories the most recent values used the in each work mode. This enables the user to
recover the parameters of a work mode in a rapid and simple manner. recover the parameters of a work mode in a rapid and simple manner
The type of memory used in the equipment is permanent and does not depend on a support battery. The type of memory used in the equipment is permanent and does not depend on a support battery The type of memory used in the equipment is permanent and does not depend on a support battery
Restore de factory settings
In the event that the user wants to restore the factory settings, because the equipment does not operate properly, it can In the event that the user wants to restore the factory settings, because the equipment does not operate properly, it can In the event that the user wants to restore the factory settings, because the equipment does not operate properly, it can
be performed with a simple operation.
1. Turn off the machine and wait until all the lights are off. 1. Turn off the machine and wait until all the lights are off.
2. Press the button (9) and keep it tight while you put up the equipment. 2. Press the button (9) and keep it tight while
3. Keep the button pressed while the machine performs the sequence start. 3. Keep the button pressed while the machine performs the sequence start.
4. Release the button. The parameters are reset to factory defaults. tton. The parameters are reset to factory defaults.

AEROARC 320

DESCRIPTION OF THE ITEMS OF EQUIPMENT
1 - Control panel
2 - Positive pole connector
3 - Remote control connector
4 - Negative pole connector
5 - Connection to three-phase power network phase power network
6 - Main switch
7 - 2A fuse

FRONT PANEL LAYOUT

1- Main selector
2- MMA Mode (VRD)
3- MMA Mode (CEL)
4- MMA Mode
5- Power output activated
6- MMA Welding curve
7- TIG Welding curve
8- Hot Start in MMA
WORK MODES DESCRIPTION
SOLTER SOLDADURA S.L.
TEMS OF EQUIPMENT
9 - Nominal Amperage Nominal Amperage
10 - Arc Force in MMA Arc Force in MMA
11 - Common problems Common problems
12 - Amp. Visualization Amp. Visualization
13- Percentage Vis Percentage Visualization
14- Time (0,1s) Time (0,1s)
15- Display Display
16- TIG TIG-LIFT ARC Mode
MMA Mode Mode
Recommended for most electrodes, for example: Rutil or Inox Recommended for most electrodes, for example: Rutil or Inox Recommended for most electrodes, for example: Rutil or Inox.
6