Remote Control; Aerotig 3320 - Solter AEROTIG 3320 DC Manual De Instrucciones

REMOTE CONTROL

It's possible to use a remote control with this equipment to change the welding current. The remote control will vary the It's possible to use a remote control with this equipment to change the welding current. The remote control will vary the It's possible to use a remote control with this equipment to change the welding current. The remote control will vary the
welding current from the minimum to the value specified in the control panel. For the connection of this control, check welding current from the minimum to the value specified in the control panel. For the
the connection paragraph (p. 14).

AEROTIG 3320

DESCRIPTION OF THE ITEMS OF EQUIPMENT
1 - Control panel
2 - Earth clamp connector
3 - Gas connector for TIG torch
4 - TIG torch connector or remote control in MMA mode
5 - Torch connector
6 - Connection to three-phase power network phase power network
7 - Main switch
8 - 2A Fuse
9 - Gas Input
FRONT PANEL LAYOUT
1- Main Selector
2- High frequency pulse mode in TIG
3- Low frequency pulse mode in TIG
4- TIG constant current mode
5- MMA Mode
6- Power output activated
7- Pre gas time
8- Starting current / time
9- Slope up time
10- Cooler activated
WORK MODES DESCRIPTIONS
SOLTER SOLDADURA S.L.
TEMS OF EQUIPMENT
ote control in MMA mode
11- Hot Start in MMA
12- I1 Intensity / I1 Time
13- I2 Intensity / I2 Time
14- Arc Force in MMA
15- Slope down time
16- Common problems
17- Amps / time of stop
18- Post gas time
19- Amp. Visualization
20- Percentage Visualization
connection of this control, check
21- Frequency Visualization Frequency Visualization
22- Time (0,1s) (0,1s)
23- Display
24- 2T operation mode (in TIG mode) 2T operation mode (in TIG mode)
25- 4T operation mode (in TIG mode) 4T operation mode (in TIG mode)
26- HF ignition in TIG mode HF ignition in TIG mode
8