Solter AEROTIG 3320 DC Manual De Instrucciones página 28

MMA Mode:
To weld coated electrodes
2T Mode
The welding is performed
while we have tight the
button.
PARAMETER DESCRIPTIONS OF MMA MODE
PARAMETER DESCRIPTIONS OF TIG MODE
SOLTER SOLDADURA S.L.
TIG Mode:
The current is always the
same.
2T Mode + High frequency
ignition.
Setting the welding current. Indicator A1 flashing.
You can select the welding current.
Initial current "Hot-start" (the display shows "Hot").
Setting the % increase over A1.
This parameter is linked to Hot-Start time and serves to achieve an increase in power for a
while at the time of starting the arc, favouring the start of certain electrodes.
Time during which the Hot-Start current will take effect.
Press the switch and change the time that the Hot-Start will act.
Reinforcement of current arc. Arc-Force.
Press to change the value. The value is the percentage that is added to the welding
current (A1) in the transfer of material drop. Promotes welding in up or down positions.
Pre-gas time
Opening gas valve time before starting the arc.
Start current
Start current from which the ramp will start.
The value is a % of the A1 current.
In 4T mode, the machine will supply this current until you release the torch button
TIG mode (pulsed arc): The
current varies between the
values of A1 and A2, with the
time specified in T1 and T2
4T Mode
The weld starts at the first
press and ends with the
second.
TIG mode (high speed pulsed
arc): The current varies
between the values of A1 and
A2 at a specified frequency.
4T Mode + High frequency
ignition.
9