Rules For Safe Operation - Egatronic 51253 Manual De Instrucciones

Rules For Safe Operation
To avoid possible electric shock or personal injury, and to avoid possible damage
• Inspect the test leads for damaged insulation or exposed metal. Check the
• Do not apply more than the rated voltage, as marked on the Meter, between
• When the Meter working at an effective voltage over 60V in DC or 30V rms
• If the value to be measured is unknown, use the maximum measurement position.
humidity, explosive, inflammable and strong magnetic field. The performance
Warning!
• Disconnect circuit power and discharge all highvoltage capacitors before
• Before measuring current, check the Meter's fuses and turn off power to the
• Replace the battery as soon as the battery indicator
• The internal circuit of the Meter shall not be altered at will to avoid damage
Meter when servicing. No abrasive and solvent should be used to prevent the
• Turn the Meter off when it is not in use and take out the battery when not
• Constantly check the battery as it may leak when it has been using for some
to the Meter or to the equipment under test, adhere to the following rules:
• Before using the Meter inspect the case. Do not use the Meter if it is
damaged or the case (or part of the case) is removed. Look for cracks or
missing plastic. Pay attention to the insulation around the connectors.
test leads for continuity. Replace damaged test leads with identical model
number or electrical specifications before using the Meter.
the terminals or between any terminal and grounding.
• The rotary switch should be placed in the right position and no any
changeover of range shall be made during measurement is conducted to
in AC, special care should be taken for there is danger of electric shock.
• Use the proper terminals, function, and range for your measurements.
• Do not use or store the Meter in an environment of high temperature,
of the Meter may deteriorate after dampened.
• When using the test leads, keep your fingers behind the finger guards.
testing resistance, continuity, diodes.
circuit before connecting the Meter to the circuit.
battery, the Meter might produce false readings that can lead to electric
• When servicing the Meter, use only the same model number or identical
electrical specifications replacement parts.
of the Meter and any accident.
• Soft cloth and mild detergent should be used to clean the surface of the
surface of the Meter from corrosion, damage and accident.
• The Meter is suitable for indoor use.
time, replace the battery as soon as leaking appears. A leaking battery will
prevent damage of the Meter.
shock and personal injury.
using for a long time.
damage the Meter.
appears. With a low
37