Saving Setup Options; Maintenance; General Service - Egatronic 51253 Manual De Instrucciones

Selection
Max. 20000; Press
HIGH
Press to select the digit you
want to edit
Max. 20000; Press
LOW
Press to select the digit you
want to edit
Zero is in the left hand side
Analogue
Bar
Graph
Zero is in the center
Saving Setup Options
At each setup Option, store your choice and exit setup by press EXIT, advance to the next
Option by press +.
To exit the Setup mode without saving the present Option, press Setup.
This chapter provides basic maintenance information including battery and fuse replacement
instruction.
Do not attempt to repair or service your Meter unless you are qualified to do so and
Warning!
A. General Service
- Periodically wipe the case with a damp cloth and mild detergent. Do not use abrasives or
solvents.
- To clean the terminals with cotton bar with detergent, as dirt or moisture in the terminals can
affect readings.
- Turn the Meter to OFF when it is not in use.
Table 5-1. Setup Selections
Option
to select
OFF
to select
OFF
10
20
10 mins
30
OFF
1
OFF
10
20
30
OFF
Zero is in

6. MAINTENANCE

have the relevant calibration, performance test, and service information
Factory
Default
Over the upper limits, beeps not
OFF
Over the lower limits, beeps not
OFF
Power off feature is disabled
Beeps continuously and icon lights on
1
No beep, icon flashes
Backlight turn off in 10 seconds
Backlight turn off in 20 seconds
10
Backlight turn off in 30 seconds
Disable backlight feature
the
center
It can only apply to DCV, DCI and °C/°F
Description
continuously
continuously
10 mins power off
20 mins power off
30 mins power off
functions
55