Specifications; Safety And Compliances; Physical Specifications - Egatronic 51253 Manual De Instrucciones

Make sure the test leads are disconnected from the circuit being tested before opening the case
bottom.
Follow Figure 6-2 and proceed as follows to replace the battery:
- Turn the rotary switch to OFF and remove all connections from the terminals.
- Remove the screw from the battery compartment, and separate the battery compartment from
the case bottom.
- Replace with a new 6F22 9V battery.
- Rejoin the case bottom and battery compartment, and reinstall the screw.
Safety and Compliances
Maximum Voltage between any Terminal
and Grounding
Certification
Compliances
Fused Protection for µAmA input
terminal:
Fused Protection for A input terminal:
Physical Specifications
Display (LCD)
Operating Temperature
Storage Temperature
Relative Humidity
Battery Type
Figure 6-2. Battery Replacement

7. SPECIFICATIONS

Refer to different range input protection voltage
IEC 61010 CAT.III1000V, CAT.IV 600V overvoltage
0.5A, 250V, fast type fuse, Ø5×20mm
10A , 250V,fast type fuse, Ø5×20mm
Digital: 20000 counts on primary display; updates
2000 counts on two secondary displays.
Analog: 40 segments; updates 10 times / second
9V NEDA 1604 or 6F22 or 006P
and double insulation standard
2-3 times / second.
0ºC~40ºC (32ºF~104ºF)
-10ºC~50ºC (14ºF~122ºF)
≤ 75% @ 0ºC~30ºC below;
≤ 50% @ 30ºC~40ºC:
57