Motor Cooling; Storing The Machine; Checking And Replacing Chain Sprocket - Stihl MSE 140 C Manual De Instrucciones

Motor Cooling

: Use a dry brush or similar tool to
clean the cooling slots at regular
intervals.
MSE 140 C, MSE 160 C, MSE 180 C, MSE 200 C

Storing the Machine

For periods of about 3 months or longer:
: Remove and clean the saw chain
and guide bar, spray with corrosion
inhibiting oil.
: Thoroughly clean the machine,
paying special attenton to the
cooling slots.
: If you use biological chain and bar
lubricant, e.g. STIHL Bioplus,
completely fill the chain oil tank.
: Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
English / USA
Checking and Replacing
Chain Sprocket
: Disconnect the plug from the power
supply.
: Remove the chain sprocket cover,
chain and guide bar.
Replace the chain sprocket:
a
– after using two chains or sooner
– if the wear marks (arrow) on the
sprocket are deeper than approx.
0.02 in (0.5 mm) since this would
reduce the life of the chain. Use a
gauge (special accessory) to check
the depth of the wear marks.
It is best to use two chains in
rotation with one sprocket.
Use only original STIHL chain sprockets.
35