Publicidad
Idiomas disponibles
Idiomas disponibles
29. MASTER MIX GAIN Control
The output level routed to the stereo outputs and REC outputs is determined ultimately by the setting of the
MASTER MIX GAIN control.
30. EFFECT SEND
The EFFECT SEND control adjusts the level of the signal on the EFFECTS bus fed to the DSP.
31. EFFECT (ECHO) RETURN
The EFFECT (ECHO) RETURN control adjusts the number of repeats of the echo effect selected with the UP /
DOWN buttons (28).
32. EFFECT GAIN
The EFFECTS GAIN fader controls the signal level sent to the MASTER MIX buses.
Rear Panel (fig. 5)
33. AC POWER IN Socket
Connect the enclosed power supply to the 3-pin mains connector on the rear of the console. Use the included
adapter to connect the console to the mains.
34. MAIN POWER Switch
This switches the mixer ON or OFF.
Note: Be sure to switch on the power to your mixer before switching on the amplification system.
4.
Connections
Unbalanced equipment may be connected to balanced inputs/outputs. Either use mono 1/4" jacks or connect
the ring and sleeve of TRS jacks. Never use unbalanced XLR connectors on the MIC input connectors when
using the phantom power supply.
Microphone input
Socket (female)
Headphones
1. Tip = left signal
2. Ring = right signal
3. Sleeve = ground
4. Tip
5. Ring
6. Sleeve
7. Strain relief clamp
V. 01 – 30/10/2012
PROMIX66N/PROMIX88N
Group & mix outputs
Plug (male)
6
©Velleman nv
Publicidad
