Adjusting The Beam - Malaguti Madison3 125ie Manual De Uso

5.14 LIGHTS
5.14.1 HEADLIGHT
• To increase visibility at night, quartz (halogen) type headlights
are fitted.
• Low beam / high beam (A - Fig. 37)
Halogen bulb 12V - 35/35 W (HS1)
1
• Parking light bulb (B - Fig. 37)
Bulb 12V - 5W (W5W)
For information about light controls, see chap. 3.12 and 3.13
2
We advise you to check if the replaced bulb works prop-
erly before refitting the headlight unit definitively.

Adjusting the beam

3
Have the beam of the headlight periodically checked by an
Authorised MALAGUTI Service Centre.
4
To check/adjust the beam, proceed as follows:
• put the vehicle in running conditions at 10 metres from a wall.
• Turn on the low beam headlights and keep the vehicle bal-
anced without a stand (lean it against a wall for instance).
5
• Remove the front air intake (P – Fig. 37a) by loosening the 2
fixing screws (V – Fig. 37a) of the light to adjust.
• With the aid of a screwdriver, turn the screw for adjusting the
projector (R - Fig. 37b), bearing in mind that turning clock-
6
wise lowers the beam and vice versa
• Adjust one light at a time, whilst covering the other.
44
Adjust the beam so that its bottom line projected on the wall is
at about 73 cm from the floor.
• Refit the front air intake.
B
A
V
Fig. 37a
P
ENGLISH
Fig. 37
R
Fig. 37b