Backlight Function; Sequence Of The Described Functions; System Start-Up; Sleep-Mode - Malaguti SPIDER MAX GT 500 Manual Diagnóstico

SPIDER MAX 500
8.

BACKLIGHT FUNCTION

8.1 LCD backlight function
The liquid crystal backlight is always on (unless the key switch is moved to the "OFF" position).
8.2 Dashboard backlight function
The dashboard backlight goes on only when the parking lights are turned on.
9.

SEQUENCE OF THE DESCRIBED FUNCTIONS

To scroll the functions press the Mode button according to the sequence indicated in the table below
As already said in the previous chapters:
• It is possible to access the Set-up menu only when the motorcycle is not in motion (speed=0). It is not possible to enter
the Set-up menu when the "Trip memory" function is selected.
• It is possible to reset the partial distance both with the motorcycle in motion or still. After selecting the TD function,
reset the value by holding the button down (for around 2 seconds) until the number 000.0 is displayed. It is not possible
to reset the TD function when the "Trip memory" function is selected.
• It is possible to reset the "Trip memory" both with the motorcycle in motion or still. After selecting the "Trip memory"
function, reset the value by holding the button down (for around 2 seconds) until all the items of the function (distance
covered, maximum and mean speed) are set to zero.

10. SYSTEM START-UP

When starting the engine (moving the key from the "OFF" to the "ON" position), the system will:
• check for the leds and backlight operation: for 3 sec all the leds are switched on (leds, backlight, immobilizer led,
except the injection led, that is managed directly by the motorcycle central unit).
• Display the "Malaguti" Logo for around 1,5 seconds.
• Display the "Spider Max" Icon and the selected unit of measurement for around 1.5 seconds.
• Display the warning message "OIL BAR" (if the pressure switch is closed to ground) for 8 seconds, whether there is
signal on the revolution counter cable.
• The system is set to the standard display.
11.

SLEEP-MODE

Every time that the key switch is turned to the "OFF" position, the system:
• searches for the mechanical zero of the engine.
• switches off all the active leds, the dashboard backlight and the 12V output, where present.
• switches to a "sleep mode", with power low consumption, system inactivity. The only function that remains on is the
current time up dating.
12.

EQUIPMENT FIRST INSTALLATION

The first time that the equipment is connected to the battery, all the pixels contained in the display are checked for
around 5 seconds, and consequently the user is prompted to select one of the units of measurement (also the software
revision is displayed in the same window).
All manuals and user guides at all-guides.com
Mode
TOD TD
Mode
18 12/04
TEMP STAND-BY
SPEED
RPM
TRIP MEMORY
SERVICE
A