Steer-Lock Mechanism Adjustment; Tools Required - Stryker Power-PRO IT Manual De Uso Y Mantenimiento

STEER-LOCK MECHANISM ADJUSTMENT

Tools Required:

• 9/16" Combination Wrench
Procedure:
If your steer-lock mechanism will not engage:
• Using a 9/16" combination wrench, adjust the barrel nuts
toward the foot end of the cot (Figure 51).
Note: After adjustment, make sure that a minimum of
one full thread is exposed on each side of the barrel nut.
If your steer-lock mechanism will not disengage:
• Using a 9/16" combination wrench, adjust the barrel nuts
toward the head end of the cot (Figure 52).
Note: After adjustment, make sure that a minimum of
one full thread is exposed on each side of the barrel nut.
www.stryker.com
Service Information
6516-109-005 REV B
Figure 51
Figure 52
Return To Table of Contents
1-83
English