Hydraulic Hose Replacement - Stryker Power-PRO IT Manual De Uso Y Mantenimiento

HYDRAULIC HOSE REPLACEMENT

Tools Required:
• 13/16" Combination Wrench
• 11/16" Combination Wrench
• (2) Saw Horse
Procedure:
1. Raise the cot to the full upright position.
2. Using two saw horses, support the litter and activate the manual release handle to relieve any hydraulic oil
pressure.
3. Using 11/16" and 13/16" combination wrenches, remove the damaged hose (A or B) (Figure 61).
Notes:
• Pay attention to the routing of the hydraulic hose for reinstallation.
• Hydraulic oil will leak from the hoses and cylinder. Lay down towels to catch the oil.
4. Reverse steps to reinstall.
5. Check functionality by running the cot up and down several times. If necessary, add hydraulic oil. See "Filling the
Hydraulics Assembly Reservoir" on
6. Verify proper operation of the unit before returning it to service.
www.stryker.com
Service Information
page 1-81.
A
Figure 61
6516-109-005 REV B
B
Return To Table of Contents
English
1-89