TOHATSU MD 30B2 Manual Del Propietário página 46

44
ENGINE OPERATION
2
3
1. Air vent screw
2. Link rod
3. From oil filter
4. Vinyl pipe
5. Open side
6. Control lever
ENOM00658-0
75, 90, 115 type (Electric oil pump)
7
Check to see by eyes if the oil line from
the oil tank to the cylinder block ((1) to
(4) in the 75, 90, 115 model) gets air
inside or not. If there is air inside the oil
line, remove it as follows.
Oil tank-Filter (1)
a. Fill the oil tank up with the specified
oil.
b. Remove the pipe of the filter inlet
side at the part (A).
c. Since the oil drains out with air, wait
until air is completely discharged
from the pipe. After checking for no
air in the oil line, reconnect the pipe
as it was and attach the clip to secure
pipe connection.
Filter-Oil Pump-Cylinder Block
[75, 90, 115: (2)–(4)]
a. Turn on the key switch.
1
4
6
5
ENOF00652-0
b. Within 1 second after the buzzer stops
sounding, remove the stop switch
lock.
c. Within 2 seconds after removing the
stop switch lock, quickly repeat pull-
ing and pushing back the stop switch
knob 2 times.
d. The buzzer sounds 3 times and the oil
pump is actuated for about 1 minute
for pressure feed or oil.
e. When air is completely removed from
the oil line, turn off the key switch.
75, 90, 115
Side mount RC type
1
1. Look
2. Key switch
3. Stop switch knob
Top mount RC type
OFF
1
1. Look
2. Key switch
3. Stop switch knob
OFF
ON
START
2
3
ENOF00653-1
ON
START
2
3
ENOF00938-C