ENOM00708-0
2. Periodic inspection
It is important to inspect and maintain your outboard motor regularly. At each interval
on the chart below, be sure to perform the indicated servicing. Maintenance intervals
should be determined according to the number of hours or number of months,
whichever comes first.
For periodic inspection and maintenance, consult your servicing dealer.
Description
Fuel System/
Fuel filter
Compres-
sion System
High pressure
*1
fuel filter
Piping/Hoses
Fuel tank
Fuel tank cap
*1
Fuel pump
*1
Air filter
*1
Drive belt
*1
Fuel Pressure
*1
Air Pressure
Ignition
Spark plug
*1
Starting Sys-
Starter motor
tem
Battery
Engine oil
Oil tank
system
Oil pipe
Oil filter
Lower Unit
Propeller
Gear oil
*1
Water pump
*1
Thermostat
*1
Power trim & tilt
Inspection intervals
First 20
Every 50
Every 100
Every 200
hours of 1
hours of 3
hours of 6
hours of 1
month
months
months
year
Replace
Replace
Replace
Replace
Replace
Replace
INSPECTION AND MAINTENANCE
Inspection procedure
Check and clean or Replace if neces-
sary.
Replace every 200 hrs or 2 years
Check and clean or Replace if neces-
sary
Clean
Check and clean or Replace if neces-
sary.
Check and clean or Replace if neces-
sary.
Check and clean or Replace if neces-
sary.
Check and Replace if necessary.
Check and replace defective parts if
necessary.
Check and replace defective parts if
necessary.
Remove carbon deposits or Replace if
necessary.
Check for salt deposits and the bat-
tery cable condition.
Check installation, fluid quantity,
gravity.
Check and clean or Replace if neces-
sary.
Check and clean or Replace if neces-
sary.
Check for bent blades, damage, wear.
Change or replenish-oil and check for
water leaks.
Check for wear or damage.
Check and Replace if necessary.
Check & replenish oil, manually oper-
ate
79
Remarks
Entire cartridge
Including filter
0.8–0.9 mm
(0.031–0.035 in)
10
Replace impeller
every 12 months.