60
ENGINE OPERATION
ENOM00920-0
7. Steering
ENOW00870-0
Sudden steering may cause passenger(s) to
be thrown overboard or falling down.
Tiller handle type
Right turn
Move the tiller handle to the left
Left turn
Move the tiller handle to the right.
7
Remote control type
Right turn
Turn the steering wheel to the right.
Left turn
Turn the steering wheel to the left.
WARNING
ENOF00892-0
ENOF00893-0
ENOM00050-0
8. Trim angle
ENOW00043-A
WARNING
Adjust the trim angle when the engine is
stopped.
Do not put hand or finger in between out-
board motor body and clamp bracket
when adjusting trim angle to prevent
injury in case the outboard motor body
falls.
Unsuitable trim position can cause loss of
control of boat. When testing a trim posi-
tion, run boat slow initially to see if it can
be controlled safely.
ENOW00044-0
WARNING
Excessive tr im up or down may lead to
unstable boat operation, potentially causing
the steering difficulty that leads to accident
during cruising.
Do not cruise at high speed if improper
trim position is suspected. Stop the boat
and readjust trim angle before continuing
cruise.
For outboard motor model with PTT
switch on the bottom cowl, do not oper-
ate the switch during cruising, or control
of boat may be lost.
The trim angle of the outboard motor
can be adjusted to suit the transom
angle of the hull, and load conditions.
Choose an appropriate trim angle that
will allow the anti-ventilation plate to
run parallel to the water surface during
operation.
ENOM00052-0
Proper trim angle
The position of the thrust rod is correct
if the hull is horizontal during operation.