GE Monogram ZET1P Manual Del Propietário página 38

The Problem Solver
Wall Over_
Save time
& money!
H_,view the
troubleshootir_g _
ti/)s on the
Jidlowb_g _paL_es
Jb:st and you m((y
not need to eallJbr
S#l"l:ice.
38
PROBLEM POSSIBLE CAUSE
OVEN WILL NOT
WORK
OVEN LIGHT(S)
DO NOT WORK
FOOD DOES NOT
BAKE OR ROAST
PROPERLY
FOOD DOES NOT
BROIL PROPERLY
OVEN WILL NOT
SELF CLEAN
"CRACKING" OR
"POPPING" SOUND
DURING CLEANING
EXCESSIVE SMOKING
OCCURS DURING
CLEANING
OVEN NOT CLEANT
AFTER A CLEAN
CYCLE
OVEN RACKS ARE
DIFFICULT TO SLIDE
• A fllse in your home may be blown or the circuit breaker tripped.
• The oven controls are not properly set.
® The oven controls are set fbr
cleaning.
If necessary, allow the oven to
cool;
then open the door.
• Make sure the O_n Mode knob is set to BAKEand the Temperature knob
is set to a temperature.
• The light bulb is defectixe. Replace the bulb.
• The oven is self:cleaning or the Sabbath feature is set. The ox>n lights do
not come on during self:cleaning or if the Sabbath feature is set.
• The oven controls are improperly set. See the Bddng or Roasting" section.
• Oxen not preheated %r a long enough time (use approximamly 10 to 15
minutes).
• Incorrect cook_tre or cook_ue of improper size being used. See the P(m
placement section.
• Racks in the wrong position. See the Baking or Roastingsection.
• Use a foil tent to slow down browning during roasting.
• Oven thermostat needs adjustment. See the Oven tlmmost(_tadjustment
section.
• This model is designed %r closed door broiling only. Close the doo_: Ahxvty's
broil with the door closed.
• The oven controls are not set at BROIL. See the Bmilingsection.
• The probe is plugged into the outlet in the oven. Remove the probe fiom
the oven.
• hnproper rack position being used.
• Food is being cooked in a hot pan. Use the broiling pan and grid that came
with your oven.
• Cook,xvue is not suimd tbr broiling. Use the broiling pan and grkt that came
with your oven.
• Ahmfinum foil used on the broiling pan and grkt has not been fitmd
properly and slit as recommended.
• In some areas the power (voltage) m W be low. Preheat the broil element
tbr approximately l0 to 15 minutes.
• The oven temperature is too high to set a self:clean operation.
Allow the oxen to cool below the locking temperature and reset the
controls.
• The controls are not properly set. See the Se_:Cle(n_ing Oven section.
• This is normal. This is the sound of the metal beating and cooling
during both the cooking and cleaning flmctions.
• Excessive soil. Turn the Oven Mode and the Temperature knobs
to OFE Open the win(to_:s to rkt the room of smoke. \_hit until the locked
door indicator light goes off Wipe up excess soil and reset the clean cycle.
• The oven was heavily soiled. Clean up hea_3.' s pillox_rs be%re starting
the clean cycle. Heavily soiled ovens may'need to self:clean again.
• Oven is connected to a 208V electrical suppl> Set your cleaning
time tbr 5 hours.
• The oven controls are not properly set. See the Se_:Cleaning" O ven section.
• The racks were cleaned in the self:clean cycle and now need periodic
lubrication. Do not spray with Pare ° or other lubricant spray's. See F.ll
extension oven tatks in the (;(n_ and Cleaning'section.