Citizen CT-S281 Manual De Usuario página 21

3.6 Selecting Paper Type
Paper type selection is available by the combination of memory switches SW4-
4 and SW4-5 by the used of "Memory Switch Select Mode". In addtion, the
following procedure is available.
1 Enter Selecting Paper Type mode.
1)Open the printer cover and remove paper. Pressing and holding the
FEED button, turn the printer power ON. The POWER LED starts blinking.
2)Release the FEED button and then close the printer cover. The paper
type currently set is indicated by the LED on the operation panel.
2 Select Paper Type.
Press the FEED button to match the paper type loaded to the LED indications
in the table below. (Refer to the table below.)
Label
Thermal paper roll
Black Mark paper
3 Save the selected Paper Type to the Printer.
Open and close the printer cover. By this operation, selected paper type is
stored in the printer memory and the Selecting Paper Type mode is terminated.
(Then, POWER LED, ERROR LED, and PAPER LED go on.) Since then, "P.Length
Set" of Memory switch 4-1 becomes "command".
When closing the printer cover during the setting a Black Mark paper or label
paper in the printer, paper length is measured, and the result will be printed
out.
* If Paper Detection error occurs at the measurement of paper length, the
printer automatically enters Adjusting Paper Sensor mode. Adjust the
sensor in accordance with "3.7 Adjusting Paper Sensor".
3.7 Adjusting Paper Sensor
Before using Black Mark paper (BM paper) or label, adjust the Paper sensor.
First remove the Sensor adjuster cover located at the opposite side of the Power
switch from the printer.
As shown in Figure 1, Level indicator LED, Black Mark sensor adjuster, and
Label paper sensor adjuster are located here in this order from the left. Adjust
them in the following procedure.
POWER LED ERROR LED
Green lit
(OFF)
Green lit
— 18 —
*PAPER LED is kept lit.
(OFF)
Red lit
Red lit