Method With Horizontal Platform - Dhollandia DH-SM.20 Instrucciones De Montaje

EN
G M
Once the position of the fitting jigs is finalised and
checked, fasten them to the rear cross member of the
loading floor of the vehicle by means of bolts, clamps or
spot welding [See Fig. 4.4].
Ensure that the centre holes of the 2 fitting jigs are per-
fectly aligned. One way to realise this, is to slide a round
bar through the holes, and to check the alignment with the
rear cross member of the loading floor.
§4.2 - Method with horizontal platform
This is recommended for the slider HTL with flat platform
(DH-SK...), and for all situations where the fixation of the
fitting jigs to the rear cross member of the vehicle floor is
problematic
Determine the distance (if any) at which the platform
should stop behind the rear cross member of the loading
floor. Prepare a corresponding spacer to insert between
the rear cross member and the platform during fitting
Mount 2 strong tubes over the front edge of the platform
[See Fig. 4.5 & 4.6].
Position the platform, with the 2 tubes attached to it, on
the loading floor of the vehicle. Slide the required spacer
(if any) between the rear cross member of the vehicle floor
and the platform, and secure the platform safely (by
means of a hoist, overhead gantry crane, supported from
underneath by means of a forklift or lifting jack,...).
DHOLLANDIA
4.4
4.5
!
27
4.6
!