Tabla de contenido
Publicidad
EN
Check if the structure of vehicle chassis and body are
strong enough to carry the proper weight of the platform
with its nominal load, and to resist the bending movement
induced by the platform and its load. Check the stability of
the vehicle and the weight on the vehicle axles in function
of the real proper weight of the HTL, and the load which is
expected to be handled. The weights indicated in the tech-
nical documentation and price list are theoretical, and may
vary according to the specific execution of the HTL.
Make sure that the body is accurately fitted to the vehicle
X
chassis. Place the vehicle on a even flat ground.
Always remove the battery clips and ABS plugs during
fitting.
Finish the HTL in accordance with the road legislation of
the country where the vehicle will be registered.
Welding should be done by qualified personnel only, and
only to the extent that such is not forbidden by the manu-
facturer of the vehicle.
When connecting hydraulic parts, make sure that the con-
nections are totally clean, and that the hydraulic circuit
doesn't get contaminated.
Grease all bearings and pins before putting the HTL into
service. It is recommended to grease all articulation bear-
ings before mounting the corresponding articulation pin.
Do not overpressure any lift functions (lift / close / retract
in or out) before full completion of the installation.
During fitting and testing, make sure that the HTL and its
moving parts don't interfere with, or cause damage to the
vehicle suspension, braking system, oil pipes and wiring
circuits.
DHOLLANDIA
9
Publicidad
Tabla de contenido
