60
INSPECTION AND MAINTENANCE
ENOM00090-B
2. Periodic Inspection
It is important to inspect and maintain your outboard motor regularly. At each interval
on the chart below, be sure to perform the indicated servicing.
Maintenance intervals should be determined according to the number of hours or num-
ber of months, whichever comes first.
Description
Fuel filter
High pressure fuel
hose*1
Fuel filter
(Vapor separator)*1
Fuel
Fuel tank
System
Fuel tank cap
Fuel pump*1
Fuel pressure*1
Hose*2
Spark plug
Ignition
System
Spark plug cap
/High tension cord*1
Starter rope*2
Starting
Starter motor*1
System
Battery
/Cable connection*1
Engine oil
10
Oil filter (4 stroke)*1
Oil strainer*1
Valve clearance*1
Engine
Timing belt*1
Idling speed*1
Compression
pressure*1
Combustion
chamber*1
Thermostat*1
Propeller
Shear pin/Split pin
Gear oil
Lower Unit
Water strainer
Water pump
impeller*2
Water pump
housing*1
Inspection intervals
First 20
Every 50
Every 100
Every 200
hours or
hours or
hours or
hours or
hours or
1 month
3 months
6 months
1 year
/
/
/
/
/
/
/
/
/
/
/
Replace
Replace
Replace
/
/
Replace
Replace
/
Replace
Every
Inspection procedure
400
2 year
Check and clean/Replace if necessary
Check/Replace if necessary
Check, clean or replace if necessary
Check and clean
Check /Replace if necessary
Check /Replace if necessary
Check
Check /Replace if necessary
Check and clean/Replace if necessary
Check /Replace if necessary
Check /Replace if necessary
Check
Check
Replace
Replace (Every 200 hours or 2 years)
Check and clean
Check and adjustment
Check and replace if necessary
Check
Check
Check
Check
Check and replace if necessary
Check and replace if necessary
Check and replace
Check
Check/Replace if necessary
Check and replace if necessary
Remarks
Refer to P63
Gap
(0.80-0.9mm)
Refer to P67
Approx.1.0L
Oil filter replace 1.2L
Refer to P61
IN : 0.13-0.17mm
EX : 0.18-0.22mm
Refer to P66
Refer to P66
Approx. 465ml
Refer to P65