Cleaning And Lubrication; Dismantling And Disposal - Sincro HB Serie Manual De Uso Y Mantenimiento

• Insert the exciter rotor (by hand, or with the help of a
rubber hammer)
• Insert the screw (2), screw it into the tab (with thread
lock) and tighten it following the torque values shown in
paragraph 6.2.4
• Reconnect the diode bridge observing the polarities
• Replace the bearing shield and protective grid.
FAN
2
1

8. CLEANING AND LUBRICATION

Any kind of cleaning work must be carried
out with the generating set shutdown and the
mains power shut off for the risk of severe
WARNING!
hazard for persons and objects.
Make sure that the generating set is shutdown and the
mains power is shut off before cleaning the outside of the
generating set with compressed air.
Never and for no reason whatsoever use
fluids or water. Do not use compressed air to
clean internal electrical parts since this could
cause short circuits or related problems.
WARNING!
ROTOR
EXCITER
1 2

9. DISMANTLING AND DISPOSAL

Only use authorised specialists.
WARNING!
All material should be eliminated in compliance with
statutory regulations.
The generator does not present any particular risks or
hazards during dismantling. To aid recovery of the material,
it is best to classify it by type (i.e. electrical parts, copper,
aluminium, plastic, etc.).
27