Making Coffee With A Preset Time - Beem THERMO 2 GO & GRIND Manual De Instrucciones

EN
5. Proceed as follows depending on the preparation method:
– To make coffee using coffee powder, press the
The display (13) shows the symbols
during the brewing process. The water is transported from the water tank through the
permanent fi lter into the thermal cup and kept warm inside it.
– To make coffee using coffee beans, press the
brewing process. The display (13) shows the symbols
button fl ashes during the grinding and brewing process. The coffee is ground and the
water is transported from the water tank through the permanent fi lter into the thermal cup
and kept warm inside it.
If the lid of the water tank is opened during use, the grinding process and / or brewing
process is stopped immediately. In this case, close the lid of the water tank again. The
grinding process and / or brewing process continues.
6. Once the brewing process has fi nished, the two symbols go out on the display and the cor-
responding control lamp is lit constantly. The device automatically switches to stand-by mode
after around two minutes. The two control lamps will go out.
If the brewing process is to be aborted prematurely, press the corresponding button (14 or
18) again.
7. Remove the thermal cup from the drainage grille (5). Place the lid (2) on the thermal cup and
turn it clockwise to secure it in place. Press the catch on the lid to open or close the drink
opening.

Making Coffee with a Preset Time

1. Prepare the coffee machine. To do this, follow points 1 – 4 of the previous section.
2. Press the PROG button (16). The display (13) shows the timer time set most recently (in the
presetting 12:00) and the symbol PROGRAM.
3. Use the STD (Hour) button (17) and MIN button (15) to set the start time you want (see
the "Handling and Operation" chapter – "Time").
4. Depending on the type of preparation, press the button
is activated, on the display the PROGRAM symbol goes out and the AUTO symbol appears.
In addition, the control lamp for the selected type of preparation is lit up constantly.
Once the preset time is reached, the device switches on automatically. On the display the AUTO
symbol goes out and the
during the grinding and / or brewing process.
08769_DE-EN-FR-ES-IT_A5_V3.indb 24 08769_DE-EN-FR-ES-IT_A5_V3.indb 24
and ON. The control lamp in the
and ON symbols appear. The corresponding control lamp fl ashes
button (18) to start the brewing process.
button (14) to start the grinding and
and ON. The control lamp in the
(18) or (14). The preset time
24
button fl ashes
13.01.2020 13:57:17 13.01.2020 13:57:17