Tilt-In-Space Mechanism - Zippie IRIS Manual De Usuario

Set-up and Adjustment

TILT-IN-SPACE MECHANISM

The tilt-in-space mechanism is installed by Sunrise. Two cable/trigger
mechanisms positively
lock the chair in place from -5º to 60º depending on the set-up. The
Zippie IRIS has the capability to provide from 0º to 5º of forward tilt.
WARNING!
Do not attempt to make this adjustment.
This adjustment must be done by an authorized supplier.
1. Tilt Operation
a. Depressing both triggers (C) at the same time disengages the
locking mechanism and allows the seat and back to rotate in space.
Releasing the triggers positively locks the rockers in place.
b. The approximate degree of tilt the seat is at can be seen on the tilt
indicator (D).
c. To lock out the tilting function, insert the locking pin (E) into the trigger
holder.
2. Tilt-stops Adjustment
Adjustments can be made to limit the amount of tilt (rotation) that the
chair provides by using the tilt-stops (A).
a. Loosen and remove the retaining screw (B).
b. Locate the tilt-stops to the desired limit either anterior or posterior.
c. Each half of tilt stop assembly should plug into directly opposing holes
on the rocker (C), then secure in place by tightening the screw (B).
3. Cable Adjustment
NOTE: Do not use lubricants on the components or assembly.
a. Loosen and remove nuts (D) and remove bracket assembly (E).
b. Loosen the jam nut (F).
c. Rotate the cable adjuster (G) until slack is removed from the
cable. Make sure the plunger pin can fully extend and retract after
adjustment.
d. Tighten jam nut (F).
e. Reinstall the bracket assembly (E).
f. Install and tighten nuts (D).
HEIGHT-ADJUSTABLE BACK WITH ADJUSTABLE STROLLER
HANDLE, (OPTIONAL).
1. Angle Adjustment
a. Loosen rear bolt (F).
b. Loosen and remove front bolt (G).
c. Set backrest at desired angle using pre-set holes.
d. Replace and tighten the front bolt (G).
e. Tighten rear bolt (F).
f. Repeat on other side.
IMPORTANT NOTE: The adjustment on each side of the chair should
be exactly equal.
NOTE: Use a torque setting of 96 in.-lbs. when setting-up the angle
adjustment of the stroller handle.
2. Angle Adjustment of the Stroller Handle
Depress both black push buttons (H) at the same time. This disengages
the stroller handle and allows it to rotate freely. Releasing the push
buttons positively locks the adjustable
stroller handle in the desired position.
3. Height Adjustment
a. Remove both bolts (I) from the backrest tube (one on each side).
b. Reposition backrest height.
c. Re-tighten both bolts (I) in the desired location.
ZIPPIE IRIS 21