Function Of The Buttons - Kettler Ergo C10 Manual De Instrucciones

START
KETTLER |
Start

FUNCTION OF THE BUTTONS

The training computer is equipped with three buttons: The rotary push-button in the centre and
one button each on the right and left housing side. The following functions are allocated to these
buttons:
In the menu view
When switching on the display, you will enter
the menu view. You can change the settings of
the user or device data, select a training and
view your training results.
1 Rotary push-button – Push
By pressing the central button, you will en-
ter the selected element. You will jump to the
selected menu point or the selected training.
2 Rotary push-button – Turn
Change the selection in the active menu. The
semi-circular figure in the lower part of the dis-
play shows additional options.
3 Left button
Return to the menu point on the higher level.
Any changes made will be discarded.
4 Right button
Call up context information. The menu item is
explained in detail.
Display switch-off
After 4 minutes of inactivity or by pressing the
left button for a long time, the display switches
off.
4 ENGLISH
1
3
2
4
In the training view
After selecting a training, you will enter the
training view. It shows all important training
values and the training profile.
By pressing the central button, you will switch
between the training modes AUTO and
MANU. This function is not available for all
trainings.
You can change the watt target level, resist-
ance or target heart rate in Profile Training.
Terminate the training cycle and start the
heart rate recovery measurement. By pressing
again, you will resume training.
Display of average values. By pressing the but-
ton, average values are displayed for several
seconds.