Solter ICON 1750 Manual De Instrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
Thank you for choosing our brand, we hope that the welding machine you have purchased will serve you well.
This instruction manual contains the necessary information and warnings for correct use within the maximum
operator safety conditions.
INVERTER welding equipment must be used by expert personnel who know and understand the risks involved
in the use of this equipment.
If you have any doubts or queries concerning this manual please contact us. Internal manipulation of the
equipment involves the risk of electric shocks. We request you not to carry out any manipulation of the
equipment. Only technically trained personnel can do this.
SOLTER SOLDADURA, S.L. denies all responsibility for negligent practices in the use or manipulation of this
machine.
This manual must be kept with the equipment purchased.
CE DECLARATION OF CONFORMITY: COMMUNITY REGULATION EC ON MACHINES EMC 89/336/EEC
AND THE EC LOW VOLTAGE REGULATION 73/23/EEC.
The welding generator has been designed and approved in accordance with European regulations EN 60974-
1:1998 EN 60974-1/A1:2000 EN60974-1/A2:2003 and EN 60974-10:2003.
It is the responsibility of those persons who use and repair this machine to comply with the requirements of the
above mentioned regulations.
Read the safety instructions carefully before starting up the equipment and beginning
welding tasks.
SOLTER welding equipment must be handled by trained personnel who have been instructed
in the use of welding equipment and who are familiar with inherent safety devices.
ELECTRICITY
The correct functioning of this machine can only be ensured through correct installation. This should
be carried out in accordance with current VDE regulations.
Disconnect the equipment if not in use for extended periods.
Do not leave the welding equipment unsupervised.
ALWAYS ensure that is earthed.
Never touch metal electrical parts with the bare skin or damp clothing.
Check that both your own clothes and the equipment or the surroundings are always dry.
Do not use worn-out or damaged welding cables. Do not overload welding cables. Use only material
in good condition.
Do not roll the cable into loops or on the equipment body housing.
Those persons carrying electronic body implant devices (PACEMAKERS) must not use equipment
of this type.
PERSONAL CLOTHING
The entire body of the welder is subject to possible contact with aggressive agents and so must be
totally protected. Use safety boots, gloves, over sleeves, gaiters and leather aprons.
BURN PROTECTION
Never touch parts of the wire or the material with your bare hands once soldered. Avoid skin contact
with airborne particles. Do not point the torch at any part of the body.
EYE PROTECTION
Welders and their assistants must use safety masks or goggles with filters which stop harmful
radiation entering the eyes. Use special and screens if possible to observe the welding area during
the process.
FIRE PROTECTION
The welding process produces flying incandescent metal parts which may cause fires. Do not use
the machine in areas where there may be inflammable gases. Clean the working area of all
inflammable material. Pay special attention to the protection of the gas cylinders in accordance with
the necessary requirements.
PROTECTION FOR GAS CYLINDERS
Cylinders containing gas (fire extinguishers etc.) store their contents at high pressure. If these suffer
any form of damage they may explode. Always treat these cylinders with care and weld as far away
from them as posible
WELDING IN TANKS WHICH MAY CONTAIN THE TRACES OF INFLAMMABLE MATERIALS
INSIDE INVOLVES A HIGH RISK OF EXPLOSION. WE RECOMMEND KEEPING AN
EXTINGUISHER READILY AVAILABLE FOR USE.
SOLTER SOLDADURA S.L.

Publicidad

Tabla de contenido
loading

Tabla de contenido