AERMEC WRC1 Manual De Usario página 76

Tabla de contenido

Idiomas disponibles

Code

Type

signal

Indoor unit

Connection error between wired panel and Indoor unit control card

Indoor unit

Status codes

Insufficient refrigerant gas quantity warning (replenishment required)

Status codes

Debug codes

Description

Air quality alarm

Incompatibility between indoor and outdoor units

Indoor unit control electric card error

Room air sensor error

Error on temperature probe on coil inlet

Error on temperature probe on coil outlet

Humidity probe error

Water temperature probe error

Jumper cap position error

Indoor unit addressing error

Dip switch setting error for selecting size

Room air probe error

Carbon dioxide probe error

Indicates that Debug mode is active

Unit on hold because of debug mode

Compressor operating parameter control procedure underway

Defrosting cycle currently underway

Unit in test mode

Pump down mode currently underway

Indoor unit air filter cleaning warning

System emergency stop (from remote system)

System emergency stop

Protected operation

Jumper cap setting error on outdoor unit (capacity selector)

Protection on system power supply phase sequence

Tabla de Contenido

Tabla de contenido