Fox Live Valve Guia Del Propietario página 16

CHARGE AND INSTALL THE BATTERY
The battery can be charged on or off the bike. To display the battery charge level, press the Power button
while the battery is connected to the main controller. Battery level is indicated by 1-5 LED lights (when 5
LED lights illuminate, the battery is fully charged).
1. Remove the cover over the charging port of the battery.
2. Insert the provided micro USB cable into the USB port of the battery. Then connect the USB cable to
any USB charging port.
3. The red charging LED will illuminate. The red charging LED will turn off when battery charging is
complete (approximately 2 hours).
4. Reinstall the cover over the charging port of the battery.
5. Remove the protective cover from the main controller mounted on the bicycle frame and store it in a
safe place.
Do not discard the controller's protective cover. This protective cover must
be transferred to the customer because is critical for protecting the main
controller when the battery is not connected (for example, during charging
off the bike). The main controller can sustain damage through exposure to
elements such as water and debris and must be covered.
6. Remove the rubber cover from the battery and store it in a safe place.
7. Install the battery onto the main controller. Align the pins on the main controller with the port in the
battery. Attach the two buckles into the grooves of the battery and click them closed.
Do not discard the battery's rubber protective cover. This protective cover
must be transferred to the customer because is critical to protect the
battery while it is in storage or being transported away from the controller.
CALIBRATE THE SYSTEM
Verify that the professional bicycle mechanic has completed the calibration sequence correctly.
This step is critical to ensuring the system responds appropriately to terrain. Calibration only needs
to take place once, unless components are replaced, in which case the system requires
recalibration.
The LIVE Valve system will not function properly unless it is calibrated according to the sequence
below. It is ok to repeat calibration.
1. Press the Power button to turn the system on.
2. Make sure the bike is upright, still, and on a level surface.
3. Press and hold the Setting Selector button for 15 seconds.
4. Release the Setting Selector button once the red OFF LED illuminates.
5. Once a green LED illuminates, press the Power button once and release it.
6. A green LED will flash 3 times to indicate the calibration process is complete.
NOTICE
NOTICE
16