Dust/Chip Extraction; Inserting The Battery; Switching On/Off - Dexter 20VJS2-28.1 Manual De Instrucciones

5. OPERATION
BEVEL ANGLE ADJUSTMENT
WARNING! Always ensure the product is switched off and remove the battery pack
before carrying out any work on the product!
The base plate can be angled up to 45° to the left or right for bevel cuts. Please always adjust the
cutting angle according to your needs.
1. Loose one hex bolts counterclockwise by using the hex key.
2. Swivel the base plate to the desired position. The base plate has lock-in points only at 0° and 45.
Other bevel angles can be adjusted using a protractor.
3. Then push the base plate towards the saw blade as far as it will go.
4. Retighten the hex bolt with the hex key.

DUST/CHIP EXTRACTION

WARNING! Attach a dust extraction device when using this product to keep the working
area clean! Wear a dust mask when operating this product! Dust can be harmful to health!
Especially dust and chips of wood that has been treated, e.g. with wood preservative or
a stain!
Attach a proper dust extraction device, e.g. a suitable vacuum cleaner attachment (Ø35mm) to the
vacuum adaptor.
1. The dust extraction pipe can be inserted to the slot of bevel angle plate until the stop with a
click sound.
2. Insert the suitable vacuum cleaner pole (35mm) into the vacuum adaptor of dust extraction pipe.

INSERTING THE BATTERY

Use only original recommended lithium-ion batteries with the voltage stated on the type plate of
your power tool. Using other batteries can lead to injuries and pose a fire hazard.
Note: The use of batteries unsuitable for your power tool can lead to malfunctions or damage to
the power tool. Insert the charged battery into the holder of battery pack until you feel it engage
and it is securely locked in place.

SWITCHING ON/OFF

To switch on the power tool, press the lock-off switch first. Then press the on/off switch and keep
it pressed.
To switch off the power tool, release the on/off switch.
Note: For safety reasons, the on/off switch cannot be locked; it must remain pressed during the
entire operation.
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO RO
BR BR
EN
EN
333