Controlling The Stroke Rate; Adjusting The Bevel Angle - Dexter 20VJS2-28.1 Manual De Instrucciones

FR FR
5. OPERATION
ES ES

CONTROLLING THE STROKE RATE

PT PT
You can variably adjust the stroke rate of the power tool when it is on by pressing in the on/off
IT IT
switch to varying extents.
Applying light pressure to the on/off switch results in a low stroke rate.
Applying increasing pressure to the switch increases the stroke rate.
EL EL
The required stroke rate is dependent on the material and the work conditions and can be
determined using practical tests.
PL PL
It is recommended that you reduce the stroke rate when placingthe saw blade on the workpiece
and when sawing plastic and aluminium.
During prolonged periods of use at a low stroke rate, the power tool may heat up significantly.
RU RU
Remove the saw blade and let the power tool run at the maximum stroke rate for around three
minutes to cool down.
KZ UA
CONTROLLING THE PENDULUM LEVEL
UA KZ
The pendulum action can be adjusted using 2 different settings. You can adjust the pendulum
action during operation using the pendulum action adjusting lever.
RO RO
0 No pendulum action
The optimum pendulum level for each application can be determined by a practical test. Note the
BR BR
following recommendations:
1. Select a lower pendulum level or switch off the pendulum action completely if you wish to
produce a finer or cleaner cutting edge.
EN
EN
2. Work on hard materials (e.g. steel) with no pendulum action.
3. You can work on soft materials and saw wood in the direction of the grain with pendulum action.

ADJUSTING THE BEVEL ANGLE

The base plate can be swivelled to the right or left to make bevel cuts up to 45°.The base plate has
lock-in points at 0° and 45° on the left and right so that the precise bevel angle can be adjusted.
Other bevel angles can be adjusted using a protractor.
NOTE: The adjusting of bevel angle is not applicable for curve cutting.
334
1 With pendulum action