Omron V1000 Guía Rápida De Referencia página 27

6 Parameter Table
Monitor
Fault Trace
U2-01 Current Fault
U2-02 Previous Fault
U2-03 Frequency Reference at Previous Fault
U2-04 Output Frequency at Previous Fault
U2-05 Output Current at Previous Fault
U2-06 Motor Speed at Previous Fault
U2-07 Output Voltage at Previous Fault
U2-08 DC Bus Voltage at Previous Fault
U2-09 Output Power at Previous Fault
U2-10 Torque Reference at Previous Fault
U2-11 Input Terminal Status at Previous Fault
U2-12 Output Terminal Status at Previous Fault
U2-13 Drive Operation Status at Previous Fault
Cumulative Operation Time at Previous
U2-14
Fault
Soft-Starter Speed Reference at Previous
U2-15
Fault
U2-16 Motor q-Axis Current at Previous Fault
U2-17 Motor d-Axis Current at Previous Fault
Fault History
U3-01
Lists the most recent fault that occurred
to
through the fourth most recent fault.
U3-04
U3-05 Accumulated operation time at the most
to recent fault through the fourth most recent
U3-08 fault.
U3-09 Lists the fifth most recent fault that
to occurred through the tenth most recent
U3-14 fault.
U3-15 Accumulated operation time at fifth most
to recent fault through the tenth most recent
U3-20 fault.
* The following faults are not recorded in the error
CPF00, 01, 02, 03, UV1, and UV2.
26
Description
log:
DI/DO
Sel.
Digital Input Function Selections
3 Multi-step speed reference 1
4 Multi-step speed reference 2
5 Multi-step speed reference 3
Jog frequency command (higher priority
6
than multi-step speed reference)
7 Accel/decel time selection 1
F Not used (Set when a terminal is not used)
14 Fault reset (Reset when turned ON)
External fault; Input mode: N.O. contact /
20 to 2F N.C. contact, Detection mode: Normal/
during operation
Digital Output Function Selections
During Run (ON: run command is ON or
0
voltage is being output)
1 Zero Speed
2 Speed Agree
6 Drive Ready
E Fault
F Not used
10 Minor fault (Alarm) (ON: Alarm displayed)
I67E-EN
Description
V1000 Quick Start Guide