Publicidad
Idiomas disponibles
Idiomas disponibles
Hook Angle
Right
Too Much Hook Angle
Wrong
WARNING:
angle according to the manufacturer's specifi-
cations for the chain you are using. Improper
hook angle will increase the chance of kickback
which can result in serious injury.
4. Check and lower depth gauges.
Depth Gauge Tool
S Place gauge tool on cutter.
S If the depth gauge is higher than the
depth gauge tool, file it level to the top
of the depth gauge tool.
WARNING:
cool, and secure the unit before storing or
transporting in a vehicle. Store unit and fuel in
an area where fuel vapors cannot reach sparks
or open flames from water heaters, electric mo-
tors or switches, furnaces, etc. Store unit with
all guards in place. Position so that any sharp
object cannot accidentally cause injury to
passersby. Store the unit out of reach of chil-
dren.
S Before storing, drain all fuel from the unit.
Start engine and allow to run until it stops.
S Clean the unit before storing. Pay particular
attention to the air intake area, keeping it free
of debris. Use a mild detergent and sponge
to clean the plastic surfaces.
S Do not store the unit or fuel in a closed area
where fuel vapors can reach sparks or an
open flame from hot water heaters, electric
motors or switches, furnaces, etc.
SERVICE AND ADJUSTMENTS
0,65 mm
Rounded
Corner
Squared Off
Corner
Maintain the proper hook
File
Depth Gauge
STORAGE
Stop engine and allow to
S Maintain rounded front corner of depth
gauge with a flat file.
NOTE:
The very top of the depth
gauge should be flat with the front half
rounded off with a flat file.
If you require further assistance or are unsure
about performing this procedure, contact your
authorized service dealer.
CARBURETOR ADJUSTMENT
WARNING:
during most of this procedure. Wear your pro-
tective equipment and observe all safety pre-
cautions. The chain must not move at idle
speed.
The carburetor has been carefully set at the
factory. Adjustments may be necessary if you
notice any of the following conditions:
S Chain moves at idle. See IDLE SPEED-T ad-
justing procedure.
S Saw will not idle. See IDLE SPEED-T adjust-
ing procedure.
Idle Speed-T
Allow engine to idle. If the chain moves, idle is
too fast. If the engine stalls, idle is too slow. Ad-
just speed until engine runs without chain
movement (idle too fast) or stalling (idle too
slow). The idle speed screw is located in the
area above the primer bulb and is labeled T.
S Turn idle speed screw (T) clockwise to in-
crease engine speed.
S Turn idle speed screw (T) counterclockwise
to decrease engine speed.
S Store in a dry area out of the reach of chil-
dren.
S Ensure the machine is cleaned and that a
complete service is carried out before long-
term storage.
S The guide bar and chain must always be cov-
ered with a scabbard when the machine is
being transported or in storage in order to
prevent accident contact with the sharp
chain. Even a non-moving chain can cause
serious cuts to yourself or persons you bump
into with an exposed chain.
CAUTION
: It is important to prevent gum
deposits from forming in essential fuel system
parts such as the carburetor, fuel filter, fuel
hose, or fuel tank during storage. Alcohol
blended fuels (called gasohol or using ethanol
or methanol) can attract moisture which leads
to fuel mixture separation and formation of
acids during storage. Acidic gas can damage
the engine.
The chain will be moving
Publicidad
