Pentax R-100 Serie Manual De Instrucciones página 100

PC(DL-01)--->R-100
1.BAUD RATE:
2.DATA LENGTH:
3.PARITY BITS:
4.STOP BITS:
5.SIGNAL CONTROL: OFF
6.XON/XOFF:
7.PROTOCOL:
8.RECORD DELIMETER: CR+LF
9.TRANS.COORD.AXIS: As you like.
Please note that these settings should be common with DL-01's.
b-5 Recommended communication settings on DL-01.
To configure DL-01 Communication setting, please read "Configuring the
software" in the Help topics of DL-01. And select values as follows.
In the "Settings" panel, "Type of Device" should be "PCS".
In the "Advanced Comm Settings" panel, each setting should be as follows.
R-100--->PC(DL-01)
Bits per second: 1200 (1200-9600 for sending "POLAR DATA")
Databits:
Parity:
Stop bits:
Flow control:
PC(DL-01)--->R-100
Bits per second:
Databits:
Parity:
Stop bits:
Flow control:
And please note that these settings should be common with R-100's.
c) Data transfer failure from DL-01 to R-100 may cause reduction of memory
capacity. If memory capacity become less, please back up required data.
d) For more information to work with DL-01, please refer to the "help" file after the installation.
to "RECEIVE RECT. DATA"
1200
8
NIL
1
OFF
OFF for "CSV" format, ON for "DC1(DC-1Z)" format
8
None
1
None
1200
8
None
1
None
99