Communication Setup; Receiving Data Setting - Pentax R-100 Serie Manual De Instrucciones

Select DC1 format and press the [ENT] key to view the DATA SEND. CONFIRMATION screen.
( Same procedure is performed at AUX )
Press the [ENT] key, and set the PC to be ready to receive.

9.3 Communication setup

The communication parameter is set when stored data is received or sent between the instrument and
the PC etc.

9.3.1 Receiving data setting

Select the 4. COMMUNICATION SETUP and press the [ENT] key to view the COMM. SETTING
SELECTION.
[1. RECEIVE RECT. DATA]
Select the 1. RECEIVE RECT. DATA and press the [ENT] key to view the following screen. Press the
[ENT] key to open the selection window.
Select each setting and press the [ENT] key.
DATA SEND. CONFIRMATION
TOKYO
After pressing [ENT],
set the PC ready to receive !
SENDING....
Remaining points:
TRANSFER
1. RECEIVE RECT.DATA
2. SEND RECT. DATA
3. SEND POLASR DATA
4. COMMUNICATION SETUP
COMM. SETTING SELECTION
1. RECEIVE RECT. DATA
2. SEND RECT. DATA
3.SEND POLAR DATA
COMM. SETTING SELECTION
1.BAUD RATE
2.DATA LENGTH
3.PARITY BITS
4.STOP BITS
5.SIGNAL CONTROL : ON
95
: 1200
: 8
: NIL
: 1
ACCEPT