Pentax R-100 Serie Manual De Instrucciones página 83

Press [F5][ACCEPT] to save the inputted data.
Then it proceeds to STATION POINT H. ANGLE SETUP screen automatically.
Station Orientation
Input the back sight point's direction angle from the start point.
Note
The direction angle set at this screen is
used at the traverse calculation which
will be executed later.
[INVERS] key
If you want to calculate the direction angle, press [F5][INVERS] key to jump INVERSE function.
Input SP as a start point and EP as a back sight point.
Result angle is set here automatically by pressing the [ENT] key at the RESULT OF INVERSE screen.
Press the [ENT] key after aiming at the reference point.
Aim at the reference point and press the [ENT] key to view the MEASURE screen.
Measuring
Aim at the Target point and press [F1][MEAS] to measure the distance.
Press [F3][ME/SAVE] to measure and save the measured data as
Press [F2][SAVE] to save the measured data as
Press the [F4][EDIT] to edit the PN, Point Name, PH, Prism Height and PC, Point Code. Press the
[ENT] key to view the each input window by pressing the up or down arrow key, and input your
desired point name or prism height or point code. Press the [F5][ACCEPT] if the current PN, PH
and PC are acceptable.
STATION POINT SETUP
2. IH : 0001.200m
3. TEMP : 27 C
4. PRESS : 994 hpa
5. ppm : 16 ppm
6. PC : XXXXX
STATION POINT H. ANGLE SETUP
H. angle xxx° xx' xx"
INPUT 0 SET
MEASURE
PN POT2
PH 0.000 m
H.angle xxx° xx' xx"
V.angle xx° xx' xx"
S.dst
MEAS SAVE ME/SAVE
MEASURE
PN POT2
PH 0.000 m
H.angle xxx° xx' xx"
V.angle xxx° xx' xx"
S.dst xx.xxx m
MEAS SAVE ME/SAVE
sideshot point.
MEASURE
1. PN: POT100
2. PH: 000.500 m
3. PC:
82
ACCEPT
HOLD INVERS
EDIT PAGE
ENT
EDIT PAGE
sideshot point.
ACCEPT