Pentax R-100 Serie Manual De Instrucciones página 85

Measuring
Aim at the Target point and press [F1][MEAS] to measure the distance.
Press [F3][ME/SAVE] to measure and save the measured data as
Press [F2][SAVE] to save the measured data as
Press [F4][EDIT] to edit the PN, Point Name, PH, Prism Height and PC, Point Code. Press the
[ENT] key to view the each input window by pressing the up or down arrow key, and input your
desired point name or prism height or point code. Press the [F5][ACCEPT] if the current PN, PH
and PC are acceptable.
Press the [ENT] to save the measured data as
If [ENT] is pushed more than twice at the one station, the last [ENT] point becomes next corner
point.
Note
Please use [SAVE] [ME/SAVE] and [ENT] properly by sideshot and corner point.
Press [F5][PAGE] to view another menu.
To finish the traverse measurement
Fixed traverse
Please measure the known point and press the [ENT] key at the last corner point.
Closed traverse
Please measure the start point and press the [ENT] key at the last corner point.
Note
Don't use the same point name ( PN ) for start point when you measure the start point from the
last corner point.
For example, change " T1 " to " T1-1 " etc.
Open traverse
It doesn't need necessarily to measure the corner point by pressing [ENT] key for calculation at
the last corner point.
The closing errors are not calculated.
MEASURE
PN POT3
PH 0.000 m
H.angle xxx° xx' xx"
V.angle xxx° xx' xx"
S.dst xx.xxx m
ME/SAVE
MEAS SAVE
sideshot point.
MEASURE
1. PN: POT300
2. PH: 000.500 m
3. PC:
corner point
MEASURE
PN POT300
PH 0.500 m
H.angle xxx° xx' xx"
V.angle xxx° xx' xx"
S.dst xx.xxx m
EDM TARGET
84
ENT
EDIT PAGE
sideshot point.
ACCEPT
PAGE