Pentax R-100 Serie Manual De Instrucciones página 9

El instrumento serie R-100 tiene como nombre de trabajo "PENTAX" como valor predeterminado.
por lo que los datos se almacenan bajo este nombre "PENTAX" a menos que se cree otro
nombre de trabajo. En este caso, los trabajos se guardan en el nuevo nombre de trabajo.
Para la elaboración del manual del PowerTopoLite Ver.1.05 se ha utilizado el Manual de referencia
de PowerTopo a la hora de crear las excelentes funciones PowerTopo.
El rango de entrada de la altura del instrumento y del prisma es "00000000.000" – "99999999.998".
El rango de entrada de las coordenadas X,Y y Z es "0000.000" – "9999.998".
The PC, Point Code, is added to the PN, Coordinates X, Y, Z and IH and you can input your desired
name of PC.
There are two Coordinates types of Rectangular and Polar. The VO,TO offset and the remote
measurement are possible when you select the Rectangular Coordinates.
When you measure in EDM SETTINGS of COARSE TRACKING, the R-100 displays a distance
value to two decimal place. But distance data of polar coordinates is displayed by EDIT function
to three decimal place, and sent to four decimal place. So " 0 " or " 00 " is added to the distance
data after the third decimal point in COARSE TRACKING mode.
For example
Displayed value:
Displayed by EDIT: 123.450
Sent polar data:
Rectangular coordinates is displayed, stored, and sent to three decimal place even if in COARSE
TRACKING or FINE MEASURE mode.
You can change the distance measurement mode during measuring operation by pressing the
EDM key at the MEASURE and VPM functions.
The same Point Name of the plural polar points can be saved from the PTL version 1.05.
The Circle radius, Line-Arc Intersection, Arc-Arc Intersection, Distance offset, Point-Dist Offset,
Arc-Dist Offset, 2D Surface and 3D Surface and Volume of the COGO of the CALCULATION are
added from the PTL version 1.05.
PowerTopoLite Ver.1.05
123.45
123.4500
8