Maintenance And Cleaning - Jay J3 Manual De Instrucciones

E N G L I S H
MAINTENANCE
Sunrise recommends that all fasteners be checked for wear, such as
loose bolts or broken components every 6 months. Loose fasteners
should be retightened according to the installation instructions. All
fasteners should be tightened to torque specifications as stated in
the hardware installation section. Contact your authorized Sunrise
Medical supplier immediately to replace any broken components.
Do not continue to use the system after identifying loose or broken
components.
EASY CLEANING
NOTE– When disassembling the back for cleaning, note the position of the
Velcro® Spine Align Components for correct reassembly.
To clean back cover
Remove cover by detaching Velcro. Detach cover from back shell.
Locate zipper on bottom of the cover and unzip. Remove foam and
turn cover inside out. Zip cover closed to avoid snagging. Machine
wash in warm water (50°C). Drip or tumble dry on low heat.
NOTE: Do not dry clean covers or use industrial washers and dryers to clean
cover. Do not steam autoclave. Do not bleach.
Reinsert the foam into the cover. Please note, the base has two lay-
ers of foam. When reinserting the foam, ensure that the thinner
"light grey" foam is facing the shell. Once the foam is secured
inside the cover, zip cover closed.
To clean back shell
Shell may be wiped clean with soap and water. No other
maintenance should be required.
To clean positioning components
Positioning components can be wiped clean with soap and water.
Do not immerse positioning components underwater.
If you have any additional questions regarding cleaning procedures,
please contact your authorized Sunrise Medical dealer.
Laundry Care Symbols
103721 Rev. E
Machine wash in warm water
(50° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean

MAINTENANCE AND CLEANING

4