BIG ASS FANS Powerfoil X3.0 Guia De Instalacion página 22

D. Secure guy wires
Over-tightening the guy wires could throw the fan off balance.
Evenly cinch all four guy wires into place using the Gripples. The guy wires should be taut, evenly spaced
around the fan, and away from the path of the airfoils. Maintain a distance of 6" to 8" (152 to 203 mm) between
the Gripples and the carabiners.
Once all of the guy wires are taut and correctly positioned, secure their loose ends with the wire rope clips and
tighten to 4.5 ft·lb (6.1 N·m). Ensure all electrical cords/cables are unobstructed by the guy wire system.
Wire Rope Clip
10. Install airfoils
Examine each airfoil to ensure the AirFence
WARNING: Disconnect power to the fan before installing the airfoils!
A. Attach winglets to airfoils
Attach a winglet to each airfoil with the Winglet Hardware. Both a Phillips head and flat head screwdriver are
required to properly secure the hardware. Secure winglets to all airfoils before attaching the airfoils to the fan.
Winglet Hardware:
a. (8) 10-24 x 3/4" Barrel
b. (8) 10-24 x 1/2" Bolt
Winglet Hardware
Board
Powerfoil
(Standard)
Winglet
18
a
b
WWW.BIGASSFANS.COM
4.5 ft·lb (6.1 N·m)
is still securely attached before proceeding.
®
Powerfoil Plus
(Optional)
© 2018 DELTA T LLC ALL RIGHTS RESERVED.
Winglet
a
b