Ottobock Movolino Arm Friction 12K12 Instrucciones De Uso página 17

Tabla de contenido

Publicidad

4.3 Adjustments and final assembly
4.3.1 Myoelectric prosthetic fitting
To install the myoelectrical components in the forearm, the assembly cover
must be removed from the forearm. To do so, loosen the screw using the
Torx screwdriver 710Y12=T10. After carefully lifting the assembly cover, it
can be removed in the direction of the elbow ball (fig. 9).
The following procedure is recommended for installation of the myoelectri-
cal components.
Installation of MyoEnergy Intergral 757B35=1
The charging receptacle contour inside the forearm component is recessed
to allow for installation of the MyoEnergy Integral charging receptacle. This
contours must be ground free. The recesses which are intended as guides
for drilling can be utilized with an 8 mm (5 / 16") twist drill. Then the charg-
ing receptacle can be mounted inside the crook of the arm according to
instructions. Do not bend the flat ribbon cable which runs from the battery
to the charging receptacle (fig. 11)!
Roughen the inside of the forearm socket with 634A3 acetone in order to
glue the lamination ring 11D12=34. Allow the acetone to evaporate prior
to gluing. Use 636K18 Sealing Resin Compact Glue.
After the lamination ring 11D12=* bonding has hardened, install the 7in1
Controller 9E420 contact plate. Press the contact plate firmly into the
lamination ring.
Installation of the electric cables in the forearm.
The electrode cables are connected in the proximal section of the elbow
joint (fig. 12). The electrode signals are transmitted to the forearm socket.
Lift the circuit board out of the forearm (fig. 10). Plug the 13E129=* elec-
trode cable into the circuit board while observing the contact markings.
Carefully reinsert the circuit board in its initial position into the forearm.
This electrode cable transmits the electrode signals to the 9E420=* 7-in-1
Controller.
Connect all cables to the 7in1 Controller 9E420 as specified.
Insert the assembly cover carefully and install. Make sure the cables are
placed properly. Cables may not be kinked or pinched.
To assemble the elbow component, pull the electrode cables through the
outer socket of the upper arm and the plug hole in the cover. Then the
Ottobock | 17

Publicidad

Tabla de contenido
loading

Tabla de contenido