Troubleshooting; Disposal - Mobicool FR34 AC/DC Instrucciones De Uso

Troubleshooting

9 Troubleshooting
Fault
The cooling device
does not function,
"POWER" LED does
not glow.
The cooling device
does not cool (plug is
inserted, "POWER"
LED is lit).
The cooling device
does not cool (plug is
inserted, "POWER"
LED flashes orange,
display is switched off).
When operating from
the DC power socket:
The ignition is on and
the cooling device is
not working and the
"POWER" LED is not
lit.
The display shows an
error message (e.g.
"Err1") and the cooling
device does not cool.
10

Disposal

➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
M
If you wish to finally dispose of the product, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
16
Possible cause
There is no voltage
present in the DC power
socket in your vehicle.
Defective compressor.
Voltage of the vehicle
battery is too low.
The DC power socket is
dirty. This results in a
poor electrical contact.
The fuse of the DC plug
has blown.
The vehicle fuse has
blown.
The cooling device has
switched off due to an
internal fault.
FR34, FR40 AC/DC
Suggested remedy
The ignition must be switched on in most
vehicles to apply current to the DC power
socket.
This can only be repaired by an
authorised customer services unit.
Test the vehicle battery and charge it as
needed.
If the plug of your cooling device
becomes very warm in the DC power
socket, either the DC power socket must
be cleaned or the plug has not been
assembled correctly.
Replace the fuse (8 A) in the DC plug,
see chapter "Replacing the fuse" on
page 14.
Replace the vehicle's DC power socket
fuse (usually 15 A). Please refer to your
vehicle's operating manual.
This can only be repaired by an
authorised repair centre.
EN