Assembly Of The Mincer - Unold 78131 Manual De Instrucciones

15. Make sure that the lead cable does not hang
over the edge of the worktop or table, since
this can cause accidents, for example if
small children pull on the cable.
16. Route the lead cable so that it is prevented
from being pulled or tripped over.
17. Never wrap the lead cable around the
appliance.
18. Always disconnect the lead cable from the
wall socket pulling on the plug, never on the
cable.
19. Before connecting the appliance to the
mains, make sure that the ON/OFF switch is
in OFF position.
20. Do not use the appliance with accessories
of other manufacturers or brands, to prevent
damage.
21. Use the mincer only indoors.
22. Never leave the mincer unattended. Keep
the appliance out of reach of children. The
mincer must not be used by children.
23. When transporting the appliance carry it
with both hands at the motor block – not at
the feed pan or the mincer.
24. Never push the food into the feeding tube
with your fingers. Always use the feedstick
for this purpose. Risk of injuries!
25. In order to avoid food blocking the feeding
worm, do not fill in with excessive pressure,
but only slightly.
the manufacturer will not be liable in the event of incorrect assembly, improper or incorrect use or if
repairs are carried out by unauthorized third parties.

aSSEmBLy OF tHE mInCEr

The switch of the mincer must be in the OFF position before the appliance is connected to the
mains!
1. Remove all packaging materials and any
transport safety devices.
2. Clean all parts with a damp cloth, as
described in the chapter "Cleaning and
maintenance" on page 19.
3. Check if the appliance is switch off.
4. Place the motor block on a solid and flat
surface. The switch has to be on the front
side. Do not cover the ventilation openings
in the bottom.
5. Insert the feeding worm into the worm
housing. The tooth wheel at the end of the
feeding worm should be greased after each
cleaning with a greasing agent admitted for
contact with foodstuff.
18
26. If the food gets stuck in the feeding worm,
press the reverse button II for a few seconds
to remove the blocking.
27. If the appliance gets repeatedly blocked,
disconnect the appliance from the mains.
Open the worm housing and remove the
obstacles. Then reassemble the appliance
and continue to process the respective food.
When switching over from I to O or to II, wait
a few seconds until the motor has stopped.
28. The mincer must only be used to mince
meat, fish, and vegetables. Do not mince
hard parts such as bones, or nuts. Do not
mince hard-fibre foods such as ginger etc.
29. Disconnect the appliance from the wall
socket after use and prior to cleaning. Never
leave the appliance unattended when it is
connected to the wall socket.
30. Let the appliance cool off before cleaning
it.
31. Never open the casing of the mincer. There
is danger of electric shock.
32. Check the appliance, the wall socket and
the lead cable regularly for wear or damage.
In case the lead cable or other parts appear
damaged, please send the appliance or the
base to our after sales service for inspection
and repair (for address, see warranty terms).
Unauthorised repairs can constitute serious
risks for the user and void the warranty.
6. Place the knife on the axle of the worm. The
flat side of the knife must faces the outside
(mincing plate), the rounded side the inside
(feeding worm). If not correctly installed,
the meat cannot be minced properly.
7. Place the required mincing plate onto the
knife. The small arresting tab at the inner
side of the worm housing must fit exactly
into the little recess of the mincing plate.
8. Firmly screw on the closing ring while
holding the mincing plate in place. Do not
overtighten.
9. Place the mincer head in the opening of
the motor block. The feeding tube faces the
user. Press the locking button down and fix