EdilKamin TINY Instalación Uso Y Mantenimiento página 42

KIT 8 (code 297360)
Note: THE FIRST PART OF THE FLEXIBLE PIPE MUST BE COMPLETELY "RELAXED" IN SUCH A
WAY TO ELIMINATE CORRUGATION. IN THIS WAY, THE INTERNAL DIAMETER WILL BE SLI-
GHTLY ENLARGED TO FAVOUR ENTRANCE.
- Define the position of the stove with respect to the walling (fig. a).
- Enable the hot air channelling control lever (see page 39).
- Place the stove in its final position and fasten it to the wall using the supplied brackets (A and B) or, if necessary, an
alternative system that will ensure the stove's stability (see page 40).
- Extend the aluminium pipe (2) for hot air channelling, without connecting the stove outlet.
- Fit the aluminium pipe to the hot air outlet (A).
- Install the terminal outlet (3) and its aluminium pipe (2).
It is essential to remember the importance of proper insulation on the pipe where the hot air passes to avoid
dispersion. Avoid curves in the pipe as much as possible.
2
1
A
fig. a
EXAMPLES OF WARM AIR CHANNELLING AND SMOKE EXHAUSTS
from the top
INSTALLATION
- Pipe blocking clamp
1 Ø 10 pipe
Smoke outle
2
tend-piece
from the back
42
KIT 8 n°
2
1
1
from the side
code
46160
162520
293430