Automatic Ignition; Manual Ignition; Manual Mode - EdilKamin TINY Instalación Uso Y Mantenimiento

INSTRUCTIONS FOR USE
Synoptic panel for the Kelly model
Panel 0/1 button
To turn the stove on or off and quit time programming (prog).
Panel MENU key
This switches the stove from Manual to Automatic mode and vice versa and allows you to programme the
timer (prog) and switch from adjusting the power to adjusting the temperature
"+" and "-" panel keys
These allow you to move within the programming mode of the timer (prog) and adjust the set temperature or power.
Remote control receiver
Display unit messages
Ac: ignition stage (flame appearance)
Ar: second ignition stage (flame stabilizing) before the operating stage
Of: shutdown stage (10 minutes)
P1 or P2 or P3: power level set
8-29: temperature set for automatic operation
H1..H7: stoppage problem identification number (see p. 55)
Pu: automatic combustion chamber cleaning under way
: motor stopping; wait a few tens of seconds before entering other commands.
When the stove is on standby, this flashes to show the mode it will restart in and when.
SCREW FEEDER LOADING
If the pellet hopper empties completely, press the + and - keys together to fill the screw feeder.
This must be done before igniting the stove again if it has shut down due to running out of pellets.
It is normal for a few pellets to be left in the hopper, which the screw feeder is not able to pick up.

Automatic ignition

Hold the 0/1 key down for two seconds with the stove on standby to start the ignition procedure. Ac appears on the display
for a few minutes (the ignition procedure does not actually take a preset time: it is automatically shortened if the electro-
nics detect that certain tests are passed). The flame appears after about five minutes. It is normal for a little smoke to be
seen in the combustion chamber before the flame appears. "Ar" appears on the display until the flame stabilizes.

Manual ignition

At temperatures of less than 3°C (too low for the heating element to glow) or if the heating element is temporarily out
of order, a firelighter may be used for ignition. Put a piece of well lit firelighter in the combustion chamber, close the
door and press 0/1.
ADJUSTING THE POWER
(when the stove is working, press the MENU key to switch between modes)

Manual mode

•
adjust the working power (from P1 to P3) and the ventilation.
49