Mixing Container Assembly; Preparation; Blender Assembly And Operation; Refill Ingredients - Profi Cook PC-KM 1004 Instrucciones De Servicio

• Do not remove the lid during operation!
• The standard programme FRUIT JUICE ends
automatically after approx. 2 minutes.

Mixing Container Assembly

Please see illustration on page 4.
Check the pre-assembly! Safety ring (1c), seal-
ing ring (1d), knife assembly (1e) and threaded
coupling (1f) must be assembled in correct order.
CAUTION:
• Never forget to place the sealing ring on the
knife assembly; otherwise the mixing con-
tainer will leak.
• Do not attach the threaded coupling askew.
• The open side of the safety ring is level with
the threaded coupling.

Preparation

1. Attach the mixing bowl without tool.
2. Cover the worm casing connector with cover
(17):
- Set the connector ring (12) to OPEN posi-
tion.
- Attach the cover to the connector ring.
- Turn the connector ring with the cover
towards LOCK position.
3. Remove the safety cover (18) from the mixing
drive shaft: Press button (19) in the direction of
the arrow and lift the safety cover at the same
time.
4. Cut all ingredients in small pieces.
5. Fill the ingredients into the mixing container.
Observe the maximum capacity.
6. Press the lid (1b) down on the mixing con-
tainer. The mixing container must be perfectly
sealed.
7. Close the lid with the stopper (1a). Observe
the recesses on the inner side of the lid. Turn
the stopper clockwise to tighten.

Blender Assembly And Operation

8. Place the mixing container on the mixing drive
shaft.
80
NOTE:
When connecting the mixing container the
pre-assembled safety ring presses down the
safety switch of the motor. Incorrect assem-
bly will prevent blender operation.
9. Connect the mains cable to a properly in-
stalled and earthed 220 – 240 V~ 50/60 Hz
wall outlet.
10. Turn the appliance on, either with the standard
programme button MIXING or with the control
knob. The respective indicator lamp lights up.

Refill Ingredients

1. Switch the appliance off.
2. Fill in ingredients or spices through the stopper
opening.
3. Close lid and stopper opening again.
4. Continue operation.

Stop Operation

1. Switch the appliance off. The indicator lamp
turns off.
2. Disconnect from mains power supply.
3. Remove the mixing container.
4. Remove the lid before pouring out the con-
tents.
5. Clean all used parts as described under

"Cleaning".

6. Cover the mixing drive shaft with the safety
cover (18).
IMPORTANT NOTE:
Do not store citrus juices or acidic foodstuffs in
metal containers.
Cleaning
WARNING:
• Disconnect from mains power supply before
cleaning.
• Do not submerge the appliance into water.
This may lead to electric shock or fire.