User Definable Parameters - Franklin Electric SubDrive Solar Manual De Instrucciones

User Definable Parameters

The following explains the menu structure and User Definable Parameters that are effective
on SubDrive Solar controllers with software versions 1.4.4 (COMM Board), 2.11 and 2.12
(main controller) and later versions.
Pressing the "Menu" button from the normal operating display enters the User Definable
Parameters menu. Pressing the up and down arrows will cycle through the parameter list.
To enter a parameter, press the "Select" button on the desired parameter. The display shows
the last saved value. Use the "Up/Down" arrows to change the parameter to the desired
value. Confirm the selection by pressing the "Select" button.
The display will then alternately flash between the new selected value and the parameter
number three times and ultimately return to the normal operating display.
Factory default settings are shown as BOLD.
Description
Factory Reset
# of Control Switch Inputs
Underload Trip
Sensitivity (%)
Select Reset Rule Type
Select Fixed Reset Rule Time
Enable Minimum Off Time
Select Minimum Off Time
Interval
22
Parameter Values
yes • Restores User Definable Parameters to factory default settings
rSt • Flashes "no" after "yes" is selected
no
• Indicates this value, as well as others, has been reset to factory default
2
• Sets number of control switches if used
P1 1 • If only one switch is required it must go in the "Run" terminal
• Count should include only run/stop control switches, but not the flow switch
0
100
• Sets the underload trip sensitivity (%)
P2 50
• Up/Down 30-100% by 1
30
on
• Fixed Reset Rule ON
P3
• Dynamic Reset Rule OFF Turns on/off fixed reset rule
off
80
• Only affects operation if P3 = ON
P4
• Up/Down 5-80 by 5 minutes
5
on
• "On" selection enables user to select a minimum
P5
• "Off" time of the system
off
1
• Only affects operation if P5 = ON
P6 10
• 1, 10-60 by 10 minutes
60