Three-Phase Motor Specifications - Franklin Electric SubDrive Solar Manual De Instrucciones

Alternate AC Source Line Reactor Specifications
A single-phase line reactor is recommended when using an alternate AC source, located
between the AC source and the controller. Without a line reactor, the drive can experience
excessive heating and will reduce performance or stop to protect itself.
• Minimum 0.4 mH inductance, rating of 25 ampere rms current, continuous, for 2.2 kW
• Minimum 0.4 mH inductance, rating of 15 ampere rms current, continuous, for 1.1 kW
• Minimum 0.4 mH inductance, rating of 10 ampere rms current, continuous, for 0.55 kW
Line reactors are typically available as three-phase line reactors. Follow the manufacturer's
instructions for use in single-phase application. The reactors can be mounted at the alternate AC
source, using the proper enclosure rating determined to be adequate.

Three-Phase Motor Specifications

MOTOR
MODEL
HP
2349029204 0.75
2345049203 1.5
2343062604 3
Maximum Motor Cable Length (in feet)
Drive Model
SD Solar 0.55 KW N3
SD Solar 1.1 KW N3
SD Solar 2.2 KW N3
Maximum Motor Cable Length (in meters)
Drive Model
SD Solar 0.55 KW N3
SD Solar 1.1 KW N3
SD Solar 2.2 KW N3
* Maximum cable length from the drive to the motor is 1000 ft (305 m). External filtering is required for motor
cable lengths exceeding this maximum distance or nuisance tripping might occur.
RATING
KW VOLTS HZ S.F.
0.55 100 60 1.5
1.1 200 60 1.3
2.2 200 60 1.15
Table 4: Motor Specification Data
AWG Copper Wire Size, (75 °C Insulation)
Motor
14 12
HP
0.75 130 220
1.5 310 500
3.0 180 290
Square Millimeter Copper Wire Size, (75 °C Insulation)
Motor
1.5 2.5
KW
0.55 20 40
1.1 70 120
2.2 30 60
Table 5: Wire Sizing Charts
MAXIMUM
FULL LOAD
LOAD
AMPS WATTS AMPS WATTS
6.9 830 8.6
5.8 1460 6.8
10.9 2920 12.5
10 8 6
340 530 830
790 1000
470 740 1000
4 6 10
70 110 190
190 290 305
100 160 260
LINE TO LINE
KVA
RESISTANCE
CODE
OHMS
1185 1.1 – 1.4
1890 2.5 – 3.0
3360 1.3 – 1.7
4
16
300
305
N
K
K
25