Nexgrill UNIVERSAL PARTS 710-0007 Manual De Instalación página 17

FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-913-8999
Step 10.
Figure 1 shows valve stem and bezel after the control knob
has been removed. Take seven large stop plates from the
component pack and place them over the valve stems as
shown (Figure 2). Make sure the tab and the stamped letter on
the stop plates are facing outward. Attach control knobs when
completed.
WARNING:
!
It is our recommendation that you do not take off the
control panel in order to gain access to the valve tips. If you
do decide to remove the control panel, the control panel
bezels must be reattached exactly as shown in Figure 2.
Failure to reattach the bezels as shown could result in
personal injury and/or property damage.
Step 11.
Carefully replace each burner, making sure the burner openings
slide over the gas valve nozzles. Using a screwdriver, secure
each burner to the firebox using the screws that were set aside
in Step 4. Carefully re-install the side burner and secure with
the cotter pin set aside in Step 4.
Step 12.
Re-install the flame tamers, cooking grates, and warming
rack following the instructions contained in the Owner's
Manual for your grill. See Illustration-10.
Note:
Follow the leak testing section instructions of this
manual prior to grill usage.
INSTALLATION INSTRUCTIONS
Figure-1
Illustration-10
17
Tab
Stop Plate
Stop Pin
Figure-2
Cooking Grates
Heat Shields
Warming Rack